Jeep Grand Cherokee 2020 Owner's Manual page 34

32 GETTING TO KNOW YOUR VEHICLE
NOTE:
When the Child-Protection Door Lock system

is engaged, the door can be opened only by
using the outside door handle even though
the inside door lock is in the unlocked posi-
tion.
After disengaging the Child-Protection Door

Lock system, always test the door from the
inside to make certain it is in the desired
position.
After engaging the Child-Protection Door Lock

system, always test the door from the inside
to make certain it is in the desired position.
For emergency exit with the system engaged,

pull up on the door lock knob (unlocked posi-
tion), roll down the window, and open the
door with the outside door handle.
WARNING!
Avoid trapping anyone in a vehicle in a
collision. Remember that the rear doors can
only be opened from the outside when the
Child-Protection locks are engaged (locked).
NOTE:
Always use this device when carrying children.
After engaging the child lock on both rear doors,
check for effective engagement by trying to
open a door with the internal handle. Once the
Child-Protection Door Lock system is engaged,
it is impossible to open the doors from inside
the vehicle. Before getting out of the car, be
sure to check that there is no one left inside.
DRIVER MEMORY SETTINGS — IF EQUIPPED
Your key fob can be programmed to recall the
same positions when the unlock button is
pushed. This feature allows the driver to store
up to two different memory profiles for easy
recall through a memory switch. Each memory
profile contains desired position settings for the
following features:
Driver seat

Easy Entry/Exit seat (if equipped)

Side mirrors

Power tilt and telescopic steering column (if

equipped)
A set of desired radio station presets

NOTE:
Your vehicle is equipped with two key fobs,

one key fob can be linked to memory position
1 and the other key fob can be linked to
memory position 2.
Be sure to program the radio presets prior to

programming the memory seats.
The memory setting switch is located on the
driver's door trim panel. The switch consists of
three buttons:
The set (S) button, which is used to activate

the memory save function.
The (1) and (2) buttons which are used to

recall either of two pre-programmed memory
profiles.
Memory Switch