Jeep Grand Cherokee 2020 Owner's Manual page 17

1st Push Of Key Fob Unlock Button
This feature lets you program the system to
unlock either the driver's door or all doors on
the first push of the unlock button on the key
fob. To change the current setting, refer to
"Uconnect Settings" in "Multimedia" for further
information.
NOTE:
If the vehicle is equipped with Passive Entry,
refer to "Keyless Enter-N-Go — Passive Entry"
located in "Doors" in "Getting To Know Your
Vehicle" for further information.
To Lock The Doors And Liftgate
Push and release the lock button on the key fob
to lock all doors and liftgate.
The turn signal lights will flash and the horn will
chirp to acknowledge the signal. Refer to
"Uconnect Settings" located in "Multimedia" for
further programmable information.
If the vehicle is equipped with Passive Entry,
refer to "Keyless Enter-N-Go — Passive Entry"
located in "Doors" in "Getting To Know Your
Vehicle" for further information.
If one or more doors are open, or the liftgate is
open, the doors will lock. The doors will unlock
again automatically if the key is left inside the
passenger compartment, otherwise the doors
will stay locked.
Replacing The Battery In The Key With
Remote Control
The recommended replacement battery is one
CR2032 battery.
NOTE:
Perchlorate Material — special handling may

apply. See www.dtsc.ca.gov/hazard-
ouswaste/perchlorate for further informa-
tion.
Do not touch the battery terminals that are

on the back housing or the printed circuit
board.
GETTING TO KNOW YOUR VEHICLE
1. Remove the emergency key by sliding the
mechanical latch on the back of the key
fob sideways with your thumb and pull the
emergency key out with your other hand.
Emergency Key Removal
1 — Emergency Key Release Button
2 — Emergency Key
15
2