Jeep Grand Cherokee 2020 Owner's Manual page 41

The Easy Entry/Easy Exit feature is disabled

when the driver seat position is less than 0.9
of an inch (22.7 mm) forward of the rear
stop. At this position, there is no benefit to
the driver by moving the seat for Easy Exit or
Easy Entry.
When enabled in Uconnect Settings, Easy Entry
and Easy Exit positions are stored in each
memory setting profile. Refer to "Driver Memory
Settings — If Equipped" in this chapter for
further information.
NOTE:
The Easy Entry/Exit feature is not enabled when
the vehicle is delivered from the factory. The
Easy Entry/Exit feature is enabled (or later
disabled) through the programmable features
in the Uconnect system. Refer to "Uconnect
Settings" in "Multimedia" for further informa-
tion.
Heated Seats — If Equipped
On some models, the front and rear seats may
be equipped with heaters located in the seat
cushions and seatbacks.
WARNING!
Persons who are unable to feel pain to the

skin because of advanced age, chronic
illness, diabetes, spinal cord injury, medica-
tion, alcohol use, exhaustion or other phys-
ical condition must exercise care when
using the seat heater. It may cause burns
even at low temperatures, especially if
used for long periods of time.
Do not place anything on the seat or seat-

back that insulates against heat, such as a
blanket or cushion. This may cause the seat
heater to overheat. Sitting in a seat that has
been overheated could cause serious
burns due to the increased surface
temperature of the seat.
Front Heated Seats
The front heated seat control buttons are
located within the climate or controls screen of
the touchscreen.
GETTING TO KNOW YOUR VEHICLE
You can choose from HI, LO, or OFF heat
settings. The indicator arrows in the
touchscreen buttons indicate the level of heat
in use. Two indicator arrows will illuminate for
HI, and one for LO. Turning the heating
elements off will return the user to the radio
screen.
Press the heated seat button

the HI setting on.
Press the heated seat button

time to turn the LO setting on.
Press the heated seat button

to turn the heating elements off.
NOTE:
Once a heat setting is selected, heat will be

felt within two to five minutes.
The engine must be running for the heated

seats to operate.
The level of heat selected will stay on until

the operator changes it.
39
2
once to turn
a second
a third time