Oil Change Reset - If Equipped - Jeep H6 Manual

23_H6_OM_EN_IN_t.book Page 82
82 GETTING TO KNOW YOUR INSTRUMENT PANEL
Unstored Messages

This message type is displayed indefinitely or
until the condition that activated the message is
cleared. Examples of this message type are
"Turn Signal On" (if a turn signal is left on) and
"Lights On" (if driver leaves the vehicle with the
lights on).
Unstored Messages Until RUN

These messages deal primarily with the Remote
Start feature. This message type is displayed
until the ignition is in the RUN state.
Five Second Unstored Messages

When the appropriate conditions occur, this
type of message takes control of the main
display area for five seconds and then returns to
the previous screen. An example of this
message type is "Automatic High Beams On."
O C R — I E
IL HANGE ESET F QUIPPED
Your vehicle may be equipped with an engine oil

change indicator system. The "Oil Change Due"
message will display in the instrument cluster
display for five seconds after a single chime has
sounded, to indicate the next scheduled oil
change interval. The engine oil change indicator
system is duty cycle based, which means the
engine oil change interval may fluctuate, depen-
dent upon your personal driving style.
Unless reset, this message will continue to

display each time the ignition is cycled to the
ON/RUN position.
To reset the oil change indicator after performing
the scheduled maintenance, refer to the following
procedure:
1. Without pressing the brake pedal, push the
ENGINE START/STOP button and cycle the
ignition to the ON/RUN position (do not start
the engine).
2. Fully press the accelerator pedal, slowly, three
times within ten seconds.
3. Cycle the ignition to the OFF position.
NOTE:
If the indicator message illuminates when you start
the vehicle, the oil change indicator system did not
reset. If necessary, repeat this procedure.