Changing Lanesense Status; Parkview Rear Back Up Camera - Jeep Grand Cherokee 2020 Owner's Manual

NOTE:
The LaneSense system operates with similar
behavior for a right lane departure.

Changing LaneSense Status

The LaneSense system has settings to adjust
the intensity of the torque warning and the
warning zone sensitivity (early/late) that you
can configure through the Uconnect system
screen. Refer to "Uconnect Settings" in
"Multimedia" for further information.
NOTE:
When enabled the system operates above

37 mph (60 km/h) and below 112 mph
(180 km/h).
Use of the turn signal suppresses the

warnings.
The system will not apply torque to the

steering wheel whenever a safety system
engages (Anti-Lock Brakes, Traction Control
System, Electronic Stability Control, Forward
Collision Warning, etc.).

PARKVIEW REAR BACK UP CAMERA

The ParkView Rear Back Up Camera allows you
to see an on-screen image of the rear
surroundings of your vehicle whenever the gear
selector is put into REVERSE. The image will be
displayed on the Navigation/Multimedia radio
display screen along with a caution note to
"check entire surroundings" across the top of
the screen. After five seconds this note will
disappear. The ParkView camera is located on
the rear of the vehicle above the rear license
plate.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the rear camera
mode is exited and the navigation or audio
screen appears again.
Manual Activation Of The Rear View Camera
1. Press the "Controls" button located on the
bottom of the Uconnect display.
2. Press the "Backup Camera" button to turn
the Rear View Camera system on.
STARTING AND OPERATING
NOTE:
The ParkView Rear Back Up Camera has
programmable modes of operation that may be
selected through the Uconnect System.
Refer to "Uconnect Settings" in "Multimedia"
for further information.
When the vehicle is shifted out of REVERSE
(with camera delay turned off), the rear camera
mode is exited and the previous screen appears
again. When the vehicle is shifted out of
REVERSE (with camera delay turned on), the
camera image will continue to be displayed for
up to 10 seconds after shifting out of REVERSE
unless the vehicle speed exceeds 8 mph
(13 km/h), the vehicle is shifted into PARK, the
vehicle's ignition is placed in the OFF position,
or the user presses image defeat "X" to exit out
of the camera video display.
253
5