Jeep Grand Cherokee 2020 Owner's Manual page 206

204 STARTING AND OPERATING
Pushing the "UP" button once will move the
suspension one position higher from the
current position, assuming all conditions are
met (i.e. engine running, speed below
threshold, etc). The "UP" button can be pushed
multiple times, each push will raise the
requested level by one position up to a
maximum position of OR2 or the highest
position allowed based on current conditions
(i.e. vehicle speed, etc).
Pushing the "DOWN" button once will move the
suspension one position lower from the current
level, assuming all conditions are met (i.e.
engine running, doors closed, speed below
threshold, etc). The "DOWN" button can be
pressed multiple times. Each push will lower the
requested level by one position down to a
minimum of Park Mode or the lowest position
allowed based on current conditions
(i.e. vehicle speed, etc.)
Automatic height changes will occur based on
vehicle speed and the current vehicle height.
The indicator lamps and instrument cluster
display messages will operate the same for
automatic changes and user requested
changes.
Off-Road 2 (OR2) – Indicator lamps 2, 3, and

4 will be illuminated when the vehicle is in
OR2.
Off-Road 1 (OR1) – Indicator lamps 3 and 4

will be illuminated when the vehicle is in OR1.
Normal Ride Height (NRH) – Indicator lamp

4 will be illuminated when the vehicle is in
this position.
Entry/Exit Mode – Indicator lamp 5 will be

illuminated when the vehicle is in Entry/Exit
Mode. If Entry/Exit Mode is requested while
vehicle speed is between 15 mph (24 km/h)
and 25 mph (40 km/h), indicator lamp 4 will
remain on solid and indicator lamp 5 will
flash as the system waits for the vehicle to
reduce speed. If vehicle speed is reduced to,
and kept below, 15 mph (24 km/h) indicator
lamp 4 will turn off and indicator lamp 5 will
flash until Entry/Exit Mode is achieved at
which point indicator lamp 5 will go solid. If
during the height change to Entry/Exit Mode,
the vehicle speed exceeds 15 mph
(24 km/h), the height change will be paused
until the vehicle speed either goes below
15 mph (24 km/h) and the height change
continues to Entry/Exit Mode, or exceeds
25 mph (40 km/h) and the vehicle height will
return to NRH. Entry/Exit Mode may be
selected while the vehicle is not moving
provided that the engine is still running and
all doors remain closed.
Transport Mode - No indicator lamps will be

illuminated. Customer driving will disable
Transport Mode.
Tire/Jack Mode - Indicator lamps 2 and 5 will

be illuminated. Customer driving will disable
Tire/Jack Mode.
Wheel Alignment Mode - Indicator lamps

4 and 5 will be illuminated. Customer driving
will disable Wheel Alignment Mode.