Headphones Operation; Controls - Jeep Grand Cherokee 2020 Owner's Manual

Headphones Operation

The headphones receive two separate channels
of audio using an infrared transmitter from the
video screen.
If no audio is heard after increasing the volume
control, verify that the screen is turned on, the
channel is not muted, and the headphone
channel selector switch is on the desired
channel. If audio is still not heard, check that
fully charged batteries are installed in the
headphones.
Rear Seat Entertainment Headphones
1 — Power Button
2 — Volume Control
3 — Channel Selection Switch

Controls

The headphone power indicator and controls
are located on the right ear cup.
NOTE:
The rear video system must be turned on before
sound can be heard from the headphones. To
conserve battery life, the headphones will auto-
matically turn off approximately three minutes
after the rear video system is turned off.
Changing the Audio Mode for Headphones
1. Ensure the Remote Control channel/
screen selector switch is in the same
position as the headphone selector switch.
NOTE:
When both the headphone and the

remote control channel selector switches
are on Channel 1, the Remote is
controlling Channel 1 and the head-
phones are tuned to the audio on
Channel 1.
MULTIMEDIA
When both the headphone and the

remote control channel selector switches
are on Channel 2, the remote is
controlling Channel 2 and the head-
phones are tuned to the audio on
Channel 2.
2. Push the Source button on the remote
control.
3. Pushing the Source button will advance to
the next mode.
4. When the Mode Selection menu appears on
screen, use the cursor buttons on the
remote control to navigate to the available
modes and push the Ok button to select the
new mode.
5. To cancel out of the Mode Selection menu,
push the Back button on the remote control.
453
9