Table of Contents
Advertisement
The power inverter is designed with built-in
overload protection. If the power rating of
150 Watts is exceeded, the power inverter will
automatically shut down. Once the electrical
device has been removed from the outlet, the
inverter should automatically reset. To avoid
overloading the circuit, check the power ratings
on electrical devices prior to using the inverter.
WARNING!
To avoid serious injury or death:
Do not insert any objects into the
receptacles.
Do not touch with wet hands.
Close the lid when not in use.
If this outlet is mishandled, it may cause an
electric shock and failure.
Sunglasses Bin Door
At the front of the console, a compartment is
provided for storing a pair of sunglasses. The
storage compartment access is a "push/push"
design. Push the chrome pad on the door to
open. Push the chrome pad on the door to
close.
Sunglasses Bin Door
ROOF LUGGAGE RACK — IF EQUIPPED
The crossbars and siderails are designed to
carry loads on vehicles equipped with a luggage
rack. The load must not exceed 150 lbs (68 kg),
and should be uniformly distributed over the
luggage rack crossbars.
GETTING TO KNOW YOUR VEHICLE
NOTE:
If not equipped with crossbars, an authorized
dealer can order and install Mopar crossbars
built specifically for this roof rack system.
Distribute cargo weight evenly on the roof rack
crossbars. The roof rack does not increase the
total load carrying capacity of the vehicle. Be
sure the total load of cargo inside the vehicle
plus that on the external rack does not exceed
the maximum vehicle load capacity.
To move the crossbars, loosen the
attachments, located at the upper edge of each
crossbar, approximately eight turns using the
anti-theft wrench provided with the Mopar
crossbars. Then, move the crossbar to the
desired position, keeping the crossbars parallel
to the rack frame. Once the crossbar is in the
desired position, retighten with the wrench to
lock the crossbar into position.
89
2
Hide quick links:
Advertisement
Table of Contents
