Jeep Grand Cherokee 2020 Owner's Manual page 274

272 STARTING AND OPERATING
6. After the shift is completed and the
NEUTRAL (N) light stays on, release the
NEUTRAL (N) button.
7. Shift the transmission into REVERSE.
8. Release the brake pedal for five seconds
and ensure that there is no vehicle
movement.
9. Press and hold the brake pedal. Shift the
transmission back into NEUTRAL.
10. Firmly apply the parking brake.
11. With the transmission and transfer case in
NEUTRAL, push and hold the ENGINE
START/STOP button until the engine turns
off.
12. Place the transmission gear selector in
PARK. Release the brake pedal.
13. Push the ENGINE START/STOP button twice
(without pressing the brake pedal), to turn
the ignition to the OFF mode.
14. Attach the vehicle to the tow vehicle using a
suitable tow bar.
15. Release the parking brake.
NOTE:
Steps 1 through 4 are requirements that

must be met before pushing the NEUTRAL (N)
button, and must continue to be met until the
shift has been completed. If any of these
requirements are not met before pushing the
NEUTRAL (N) button or are no longer met
during the shift, then the NEUTRAL (N) indi-
cator light will flash continuously until all
requirements are met or until the NEUTRAL
(N) button is released.
The ignition must be in the ON/RUN mode for

a shift to take place and for the position indi-
cator lights to be operable. If the ignition is
not in the ON/RUN mode, the shift will not
take place and no position indicator lights will
be on or flashing.
A flashing NEUTRAL (N) position indicator

light indicates that shift requirements have
not been met.
If the vehicle is equipped with Quadra-Lift air

suspension, the engine should be started
and left running for a minimum of
60 seconds (with all the doors closed) at
least once every 24 hours. This process
allows the air suspension to adjust the
vehicle's ride height to compensate for
temperature effects.
Shifting Out Of NEUTRAL (N)
Use the following procedure to prepare your
vehicle for normal usage:
1. Bring the vehicle to a complete stop,
leaving it connected to the tow vehicle.
2. Firmly apply the parking brake.
3. Start the engine.
4. Press and hold the brake pedal.
5. Shift the transmission into NEUTRAL.