Jeep Grand Cherokee 2020 Owner's Manual page 32

30 GETTING TO KNOW YOUR VEHICLE
To Unlock/Enter The Liftgate
The liftgate Passive Entry unlock feature is built
into the electronic liftgate release. With a valid
Passive Entry key fob within 5 ft (1.5 m) of the
liftgate, push the electronic liftgate release to
open with one fluid motion.
NOTE:
If the vehicle is unlocked, the liftgate will

open with the handle and no key fob is
required.
If the vehicle is locked, and the liftgate is

unlocked by using Passive Entry, the vehicle
doors will remain locked (unless "Unlock All
Doors 1st Press" is selected in the Passive
Entry settings).
The liftgate (and vehicle doors if unlocked)

must be locked using the lock button on the
key fob, the Passive Entry lock button, or the
lock buttons on the interior front door panels.
Electronic Liftgate Release/Liftgate Passive Entry
Location
1 — Electronic Liftgate Release
2 — Lock Button Location
To Lock The Liftgate
With a valid Passive Entry key fob within 5 ft
(1.5 m) of the liftgate, push the Passive Entry
lock button located on the outside liftgate door
handle.
NOTE:
The liftgate Passive Entry lock button will lock all
doors and the liftgate. The liftgate unlock
feature is built into the electronic liftgate
release.
General Information
The following regulatory statement applies to all
Radio Frequency (RF) devices equipped in this
vehicle:
This device complies with Part 15 of the FCC
Rules and with Innovation, Science and
Economic Development Canada license-exempt
RSS standard(s). Operation is subject to the
following two conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any interference
received, including interference that may
cause undesired operation.
Le présent appareil est conforme aux CNR
d`Innovation, Science and Economic
Development applicables aux appareils radio
exempts de licence. L'exploitation est autorisée
aux deux conditions suivantes:
1. l'appareil ne doit pas produire de
brouillage, et
2. l'utilisateur de l'appareil doit accepter tout
brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compro-
mettre le fonctionnement.