Jeep Grand Cherokee 2020 Owner's Manual page 290

288 IN CASE OF EMERGENCY
4. Turn the low or high beam bulb a quarter
turn counterclockwise to remove from
housing.
5. Disconnect the electrical connector and
replace the bulb.
Front Turn Signal Lamp
The front turn signal lamps are LEDs. See an
authorized dealer for service.
1. Open the hood.
2. Access the back of the headlamp.
NOTE:
The air filter housing must be removed.

The windshield washer reservoir may need to

be rotated out of the way by removing the
fastener.
Coolant reservoir (if equipped) will need to be

repositioned by removing the fasteners, and
moving the unit out of the way.
3. Turn the turn signal bulb a quarter turn
counterclockwise to remove from housing.
4. Disconnect the electrical connector and
replace the bulb.
CAUTION!
Do not touch the new bulb with your fingers.
Oil contamination will severely shorten bulb
life. If the bulb comes in contact with any oily
surface, clean the bulb with rubbing alcohol.
Front Fog Lamps
Please see an authorized dealer for service.
Rear Tail, Stop, and Turn Signal Lamps
1. Raise the liftgate.
2. Remove the two push-pins from the tail
lamp housing.
Tail Lamp Push Pins
3. Grasp the tail lamp and pull firmly rearward
to disengage the lamp from the aperture
panel.
4. Twist socket counterclockwise and remove
from lamp.
Rear Of Tail Lamp
1 — Rear Turn/Stop Bulb Socket
2 — LED Tail Connector – Do Not Remove
3 — Backup Bulb Socket
5. Pull the bulb to remove it from the socket.
6. Replace the bulb, reinstall the socket, and
reattach the lamp assembly.