Jeep Grand Cherokee 2020 Owner's Manual page 35

Programming The Memory Feature
To create a new memory profile, perform the
following:
1. Place the vehicle's ignition in the ON/RUN
position (do not start the engine).
2. Adjust all memory profile settings to desired
preferences (i.e., seat, side mirror, power tilt
and telescopic steering column [if
equipped], and radio station presets).
3. Push and release the set (S) button on the
memory switch.
4. Within five seconds, push and release
either of the memory buttons (1) or (2). The
instrument cluster display will display which
memory position has been set.
NOTE:
Memory profiles can be set without the vehicle
in PARK, but the vehicle must be in PARK to
recall a memory profile.
Linking And Unlinking The Remote Keyless
Entry Key Fob To Memory
Your key fobs can be programmed to recall one
of two pre-programmed memory profiles by
pushing the unlock button on the key fob.
NOTE:
Before programming your key fobs you must
select the "Memory Linked To Fob" feature
through the Uconnect system settings. Refer to
"Uconnect Settings" in "Multimedia" for further
information.
To program your key fobs, perform the following:
1. Place the vehicle's ignition in the OFF
position.
2. Select a desired memory profile, 1 or 2.
3. Once the profile has been recalled, push
and release the set (S) button on the
memory switch.
4. Within five seconds, push and release
button (1) or (2) accordingly. "Memory
Profile Set" (1 or 2) will display in the
instrument cluster.
5. Push and release the lock button on the key
fob within 10 seconds.
GETTING TO KNOW YOUR VEHICLE
NOTE:
Your key fobs can be unlinked to your memory
settings by pushing the set (S) button, and
within 10 seconds, followed by pushing the
unlock button on the key fob.
Memory Position Recall
NOTE:
If a recall is attempted when the vehicle is not in
PARK, a message will be displayed in the instru-
ment cluster display.
To recall the memory settings using the

memory switch, push memory button
(1) or (2) on the memory switch.
To recall the memory settings using the key

fob, push the unlock button on the key fob
linked to memory position 1 or 2.
A recall can be canceled by pushing any of the
memory buttons during a recall (S, 1, or 2), or by
pushing any of the seat adjustment switches.
When a recall is canceled, the driver's seat and
telescopic steering column (if equipped) will
stop moving. A delay of one second will occur
before another recall can be selected.
33
2