Adjusting The Height Of The Center Mount Footrest - Invacare Formula PTO Plus Service Manual

SECTION 12—CENTER MOUNT FOOTRESTS
Seat Frame
Mounting Bracket
Center
Mount
Footrest
FIGURE 12.1 Removing/Installing the Center Mount Footrest

Adjusting the Height of the Center Mount Footrest

While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to FIGURE 12.2.
1. Remove the two mounting screws that secure the footrest extension tube to the
extension tube housing.
2. Adjust the footrest extension tube to the desired height and align the corresponding
holes to the extension tube mounting holes.
3. Reinstall the two mounting screws to secure the footrest extension tube to the
extension tube housing. Securely tighten.
4. Repeat STEPS 1-3 for the other footrest extension tube.
NOTE: ASBA seat shown.
Center mount footrest
installs the same way on
adjustable ASBA seats.
Extension Tube Mounting Holes
FIGURE 12.2 Adjusting the Height of the Center Mount Footrest
™
Formula PTO Plus Powered Seating
Seat Frame
Release
Lever
Ratchet Housing
WARNING
Mounting Screws
Height Adjustment
Holes
54
NOTE: ASBA seat shown.
Center mount footrest installs
the same way on adjustable
ASBA seats.
Rigging Pivot Pin
Seat Frame
Release Lever
Extension Tube Housing
Extension Tube
Part No 1125031