Adjusting The Drive Lockout Sensor - Invacare Formula PTO Plus Service Manual

SECTION 17—MK6I ELECTRONICS
9. Secure the drive lockout sensor cable to the wheelchair with tie-wraps, making sure
there is no excess cable which loops away from the wheelchair. Refer to Securing the
Cables on page 143 for more information about properly securing the cables.
NOTE: Ensure the cables are secured in the locations noted in STEP 4.
10. Adjust the drive lockout sensor. Refer to Adjusting the Drive Lockout Sensor on
page 120.
FIGURE 17.2 Replacing the Drive Lockout Sensor / Adjusting the Drive Lockout Sensor

Adjusting the Drive Lockout Sensor

NOTE: For this procedure, refer to FIGURE 17.2 on page 120.
1. Tilt the seating system until the joystick indicates drive lockout:
• MK6i MPJ+ Joysticks -
joystick or display unit.
• SPJ+ Joysticks - Left to right chase alternating with a steady display.
2. Loosen the mounting screw securing the drive lockout sensor clamp to the tilt
assembly.
3. Slowly move the drive lockout sensor in the following manner:
• Towards the Front of the Wheelchair - Decreases drive lockout angle.
• Towards the Rear of the Wheelchair - Increases drive lockout angle.
4. Tighten the mounting screw to secure the drive lockout sensor in the desired position.
™
Formula PTO Plus Powered Seating
Mounting Screw
Drive Lockout
Cable
TILT WARNING or
Drive Lockout Sensor
Drive Lockout Clamp
Tilt Assembly
SPM Inhibited displays on the
120
Part No 1125031