Invacare Formula PTO Plus Service Manual page 110

SECTION 16—TILT
Installing the Tilt Actuator
NOTE: For this procedure, refer to FIGURE 16.6 on page 111.
1. Ensure the seat assembly is supported from behind by an assistant or a stationary
object.
2. Position the new actuator as shown in FIGURE 16.6.
3. Insert the clevis pin to secure the rear of the actuator to the tilt frame support
(Detail "C").
4. Install the washer onto the clevis pin (Detail "C").
5. Install the cotter pin through the clevis pin.
6. Install one threaded pivot pin to secure the left side of the actuator to the front of the
tilt frame (Detail "B").
NOTE: The tilt frame should now be supported by the actuator.
7. Install the remaining threaded pivot pin to secure the right side of the actuator to the
front of the tilt frame (Detail "B").
8. Position the cam switch cover onto the actuator as shown in FIGURE 16.6.
9. Secure the cam harness cable to the tilt assembly using the two cap screws
(Detail "A"). Torque to 75 in-lbs ± 20%.
™
Formula PTO Plus Powered Seating
110
Part No 1125031