Adjusting The Angle Of The Center Mount Footrest; Adjusting The Center Mount Footplate Angle - Invacare Formula PTO Plus Service Manual

Adjusting the Angle of the Center Mount Footrest

While the wheelchair is moving, minimum ground clearance for the front rigging is
three inches. If the wheelchair is not moving, the front rigging MUST maintain a
minimum of one inch ground clearance - otherwise personal injury and damage may
result.
NOTE: For this procedure, refer to FIGURE 12.3.
1. Engage the release lever with one hand
and move the center mount footrest to
the desired angle with the other hand.
2. Disengage the release lever to lock the
center mount footrest in the new
position.

Adjusting the Center Mount Footplate Angle

After 2/14/07
NOTE: For this procedure, refer to FIGURE 12.4.
1. Loosen, but DO NOT remove, the two
rear mounting screws and side
mounting screw.
2. Move the footplate to the desired angle.
3. Tighten the two rear mounting screws
and side mounting screw to secure the
footplate in the desired position.
4. Repeat STEPS 1 and 2 for the other
footplate.
Part No 1125031
SECTION 12—CENTER MOUNT FOOTRESTS
WARNING
Center
Mount
Footrest
NOTE: ASBA seat shown. Center mount
footrest installs the same way on adjustable
ASBA seats.
FIGURE 12.3 Adjusting the Angle of the
Center Mount Footrest
Rear Mounting
Screws
Side Mounting
Screw
FIGURE 12.4 Adjusting the Center Mount
Footplate Angle - After 2/14/07
55
Release Lever
Center Mount
Front Rigging
Footplate
™
Formula PTO Plus Powered Seating