Invacare Formula PTO Plus Service Manual page 104

SECTION 16—TILT
Using the Single Function Toggle Switch (TRSS)
NOTE: For this procedure, refer to FIGURE 16.1 on page 104.
NOTE: The single function toggle switch is used on systems with MK
NOTE: The directions indicated in this procedure apply to wheelchairs with the single function
toggle switch mounted on the right side of the wheelchair.
Increasing the Tilt Angle
1. Make sure the wheelchair is on a level surface.
2. Push the single function toggle switch FORWARD towards the FRONT of the
wheelchair until the desired angle is achieved.
Decreasing the Tilt Angle
1. Pull the single function toggle switch BACK towards the REAR of the wheelchair until
the desired angle is achieved.
FIGURE 16.1 Using the Single Function Toggle Switch (TRSS)
Using the Powered Seating Switch
NOTE: The powered seating switch can be used with all MK6i joysticks.
NOTE: The powered seating switch will alternate functions (increase tilt angle, decrease tilt angle)
after it has been released for a minimum of three seconds.
1. Make sure the wheelchair is on a level surface.
2. Press the powered seating switch once to activate the actuator.
3. Press the powered seating switch again (after at least 3 seconds) to activate the
actuator in the opposite direction.
™
Formula PTO Plus Powered Seating
Single Function Toggle Switch
104
electronics only.
5
LED
Part No 1125031