Invacare Formula PTO Plus Service Manual page 58

SECTION 13—POWER ELEVATING LEGRESTS
2. Insert the mounting pin of power legrest into the mounting hole of the hanger
assembly (Detail "A").
NOTE: Make sure the legrest sits flush on the hanger assembly.
3. Rotate the power legs toward the inside of the wheelchair until it locks in place.
NOTE: The footplate will be on the inside of the wheelchair when locked in place.
4. Repeat STEPS 1-3 for the opposite legrest.
5. Connect power legrest connector to the harness (Detail "B").
6. If necessary, adjust powered legs. Refer to Adjusting the Power Elevating Legrests on
page 59.
Removing the Power Elevating Legrests
1. Disconnect power legrests from the harness.
2. Push powered legrest release handle toward the opposite side of the wheelchair and
swing legrest to the outside of the wheelchair.
3. Lift powered legrest and remove from wheelchair.
4. Repeat STEPS 1-3 for opposite power legrest.
DETAIL "A"
Mounting
Hole
Hanger
Assembly
Legrest Release
Handle
NOTE: ASBA seat shown. Power elevating legrest installs the same way on adjustable ASBA
seats.
FIGURE 13.1 Installing/Removing the Power Elevating Legrests
™
Formula PTO Plus Powered Seating
Calf Pad
Mounting Pin
Footplate
Harness
Power
Legrest
Connector
58
DETAIL "B"
Part No 1125031