SECTION 15—SEAT
7. Remove prop rod from the clip located on the Formula PTO Plus frame and engage
the prop rod end into the front seat post as shown in FIGURE 15.1.
8. Gently allow weight of seat assembly to be supported by the prop rod.
NOTE: Only leave the seat assembly in the up/open position while performing any necessary
procedures. Always lower the seat assembly to the down/closed position when not servicing the
wheelchair. Ensure the seat is locked in place before using.
TDX
Mounting Hole
Formula PTO Plus Frame
Screw
Washer
M71
Formula PTO
Plus Frame
Front Seat
Post
™
Formula
PTO Plus Powered Seating
Seat Bracket
Mounting
Hole
Clip
Prop
Rod
FIGURE 15.1 Tilting the Seat Assembly
Prop Rod
Clip
Formula PTO
Plus Frame
Screw
Washer
82
Screw
Washer
M91
Mounting
Hole
Clip
Prop
Rod
Front Seat
Post
Part No 1125031