Invacare Formula PTO Plus Service Manual page 63

6. Align the two T-nuts on depth adjustment bracket assembly with channel on legrest.
Slide calf pad assembly to desired height. Tighten the two hex mounting screws
securely.
7. Repeat STEPS 1-6 for opposite side.
Adjusting the Calf Pad Height
NOTE: For this procedure, refer to FIGURE 13.7.
1. Loosen, but DO NOT remove, the two hex head screws that secure depth adjustment
bracket to the T-nuts.
2. Slide the calf pad assembly with T-nuts
up or down in the channel to desired
position.
3. Holding the calf pad assembly in
position, tightly secure the hex screws
to the T-nuts.
4. Repeat STEPS 1-3 for opposite side, if
necessary.
Adjusting the Length for Power Legrest
NOTE: For this procedure, refer to FIGURE 13.8.
1. Loosen, but DO NOT remove, the
length adjustment button screw (screw
also secures lower end of shroud).
2. Slide footplate with outer cover up or
down to desired position.
3. Securely tighten length adjustment
button screw.
4. Repeat STEPS 1-3 for remaining legrest.
Part No 1125031
SECTION 13—POWER ELEVATING LEGRESTS
Hex Head
Screws
(T-Nuts
are NOT
SHOWN)
FIGURE 13.7 Adjusting the Calf Pad Height
Button
Screw
FIGURE 13.8 Adjusting the Length for
Power Legrest
63
Formula
Depth
Adjustment
Bracket
Channel
Outer Rail
NOTE: Length
adjustment is
from 15½ - 20
inches.
Outer
Cover
™
PTO Plus Powered Seating