Removing/Installing The Multiple Actuator Interface Box (S4Wsb) - Invacare Formula PTO Plus Service Manual

SECTION 17—MK6I ELECTRONICS
Removing
1. Disconnect the connector from the 4-way switch box (not shown).
2. Remove any tie-wraps securing the cable to the powered seating system.
3. Remove the quad push button from the powered seating system.
Installing
1. Connect the connector to the 4-way switch box.
2. Secure the quad push button to the powered seating system in the desired location.
3. Secure the cable to the powered seating system using tie-wraps.
4. Test the seating system function to ensure the cable is not pulled, crushed or pinched.
Quad Push Button
Cable
Connector
FIGURE 17.6 Removing/Installing the Quad Push Button (QPB)
Removing/Installing the Multiple Actuator Interface
Box (S4WSB)
NOTE: For this procedure, refer to FIGURE 17.7 on page 126.
NOTE: Use the multiple actuator interface box to operate the seating system with multiple
actuators (power legs, for example) using the MPJ+ joystick and also a 4-way toggle switch or quad
push button.
Removing
1. Loosen, but do not remove, the two hex screws securing the mounting plate to the half
clamps.
125 ™
Part No 1125031 Formula PTO Plus Powered Seating