Removing/Installing The 4-Way Switch Box (4Wsb) - Invacare Formula PTO Plus Service Manual

SECTION 17—MK6I ELECTRONICS
Installing
1. Connect the network connector. Refer to Connecting/Disconnecting Network
Connectors on page 118.
2. Secure the sanode to the powered seating system using tie-wraps.
NOTE: Secure the sanode in a location that will enable the powered seating system to function
without pulling, crushing or pinching the cable.
3. If adding the sanode to the seating system, further programming in the POWERED
SEATING menu is necessary to allow the joystick to operate the powered seating
functions:
• ACTUATOR CONTROL - needs to be set to 4-switch or other desired mode.
• ACTUATOR SELECTION - needs to be set to the desired actuator controls for each
joystick direction.
Network Connector

Removing/Installing the 4-Way Switch Box (4WSB)

NOTE: For this procedure, refer to FIGURE 17.4 on page 123.
NOTE: Use the 4-way switch box to operate the seating system with multiple actuators (power
legs, for example) using a 4-way toggle switch (FWT) or quad push button (QPB).
Removing
1. Loosen, but DO NOT remove, the two hex screws securing the mounting plate to the
half clamps.
2. Remove the half clamps from the armrest.
3. Remove the two mounting screws securing the 4-way switch box to the mounting
plate.
4. Remove any tie-wraps (not shown) securing the cable to the powered seating system.
5. Disconnect the network connector. Refer to Connecting/Disconnecting Network
Connectors on page 118.
™
Formula PTO Plus Powered Seating
Cable
FIGURE 17.3 Removing/Installing the Sanode
Sanode
Fasten with Tie-Wraps Here
122
Part No 1125031