Adjusting the Height of the Center Mount Footrest
NOTE: For this procedure, refer to FIGURE 16.8.
After adjusting the Center Mount Footrest, minimum ground clearance for the
footrest in the driving position is 3 inches. If the Center Mount Footrest is in the
retracted position and the wheelchair is not moving, the footrest must maintain a
minimum of 1 inch ground clearance - otherwise personal injury and damage may
result.
1. Remove the two mounting screws that secure the footrest extension tube to the
extension tube housing.
2. Adjust the footrest extension tube to the desired height and align the corresponding
holes to the mounting holes on the extension tube housing.
3. Reinstall the two mounting screws to secure the footrest extension tube to the
extension tube housing. Securely tighten.
4. Repeat STEPS 1-3 for the other extension tube.
Extension Tube Mounting Holes
FIGURE 16.8 Adjusting the Height of the Center Mount Footrest
Part No 1141449
WARNING
Mounting Screws
Height
Adjustment
Holes
75
SECTION 16—FRONT RIGGINGS
Seat Frame
Release Lever
Extension
Housing
Extension Tube
®
Pronto
™
™
M71
with SureStep