Removing/Installing The Dual Leg Integrated Actuator Module (Dliam) - Invacare Formula PTO Plus Service Manual

Removing/Installing the Dual Leg Integrated Actuator
Module (DLIAM)
NOTE: For this procedure, refer to FIGURE 17.8.
NOTE: Use the DLIAM when powered elevating legrests (ELRPW) are installed on the seating
system.
Removing
1. Remove the two mounting screws securing the DLIAM to the seat pan.
2. Remove any tie-wraps securing the DLIAM cables to the powered seating system.
3. Disconnect the power elevating legrest harness connector.
4. Disconnect the network connector. Refer to Connecting/Disconnecting Network
Connectors on page 118.
Installing
1. Secure the DLIAM to the seat pan using the two mounting screws.
2. Connect the power elevating legrest harness connector.
3. Connect the network connector. Refer to Connecting/Disconnecting Network
Connectors on page 118.
4. Secure the cables to the powered seating system using tie-wraps.
5. Test the seating system function to ensure the cables are not pulled, crushed or
pinched.
6. If adding the DLIAM to the seating system, further programming is necessary to allow
the joystick or 4-way toggle switch to operate the powered legs:
• CALIBRATIONS menu - 4-WAY SWITCH - needs to be set to the desired actuator
controls for each direction on the 4-way toggle switch.
• POWERED SEATING menu - ACTUATOR SELECTION need to be set for each
joystick direction.
Part No 1125031
SECTION 17—MK6I ELECTRONICS
127
Formula
™
PTO Plus Powered Seating