Ricoh Aficio 1515 Service Manual page 259

9 March 2004
Address
68053B International dial tone continuous
tone time
68053C International dial tone permissible
drop time
68053D International dial wait interval (LOW)
68053E International dial wait interval (HIGH)
68053F Country dial tone upper frequency
limit (HIGH)
680540 Country dial tone upper frequency
limit (LOW)
680541 Country dial tone lower frequency
limit (HIGH)
680542 Country dial tone lower frequency
limit (LOW)
680543 Country dial tone detection time
680544 Country dial tone reset time (LOW)
680545 Country dial tone reset time (HIGH)
680546 Country dial tone continuous tone
time
680547 Country dial tone permissible drop
time
680548 Country dial wait interval (LOW)
680549 Country dial wait interval (HIGH)
68054A Time between opening or closing the
DO relay and opening the OHDI
relay
68054B Break time for pulse dialing
68054C Make time for pulse dialing
68054D Time between final OHDI relay
closure and DO relay opening or
closing
68054E Minimum pause between dialed
digits (pulse dial mode)
68054F Time waited when a pause is
entered at the operation panel
680550 DTMF tone on time
680551 DTMF tone off time
680552 Tone attenuation level of DTMF
signals while dialing
680553 Tone attenuation value difference
between high frequency tone and
low frequency tone in DTMF signals
Function
3-39
NCU PARAMETERS
Unit
Belgium ☛ Note 2
20 ms
Hz (BCD) If both addresses contain
FF(H), tone detection is
disabled.
If both addresses contain
FF(H), tone detection is
disabled.
20 ms If 680543 contains FF,
the machine pauses for
the pause time (680548 /
680549).
1 ms ☛ Notes 3, 6 and 8
SP2-103-11
1 ms ☛ Note 3
SP2-103-12
1 ms ☛ Note 3
SP2-103-13
1 ms ☛ Notes 3, 6 and 8
SP2-103-14
This parameter is only
valid in Europe.
20 ms ☛ Note 3 and 8
SP2-103-15
SP2-103-16
☛ Note 3
1 ms SP2-103-17
SP2-103-18
-N x 0.5 –3.5 SP2-103-19
dBm
☛ Note 5
-dBm x 0.5 SP2-103-20
The setting must be less
than –5dBm, and should
not exceed the setting at
680552h above.
☛ Note 5
Remarks