Nvram Data Upload/Download; Uploading Nvram Data - Ricoh Aficio 1515 Service Manual

FIRMWARE UPDATE PROCEDURE

5.2.3 NVRAM DATA UPLOAD/DOWNLOAD

This section (5.2.3) is for the MFP model (B130), the copier/facsimile model (B168),
and the copier/printer/scanner model (B169) only. This section illustrates how to
copy the data from the controller NVRAM to an SD card (☛
Uploading NVRAM Data) or from an SD card to the controller NVRAM (☛
Downloading SD Card Data). For the workflow to copy the data in the BICU
NVRAM, see section 5.1.9.
NOTE: The procedure in this section does not upload or download the NVRAM
data on the BICU. See section 5.1.9 for the procedure to upload or
download the NVRAM data on the BICU.

Uploading NVRAM Data

You can copy the NVRAM data to an SD card.
1. Activate the SP mode.
2. Select SP5-990-001, and output the SMC report. You may need these data
when uploading fails.
3. Turn off the main power switch.
4. Insert the SD card into the lower slot.
5. Turn on the main power switch.
6. Activate the SP mode.
7. Select SP5-824-001 (NVRAM Upload).
8. Press the Execute key. The copier starts uploading and makes the following file
in the following folder:
NVRAM\serial_number.NV
where "serial_number" is the serial number. If, for example, the serial number
is "B0700017," the folder name and the file name are as follows:
NVRAM\B0700017.NV
9. Make a label that indicates the contents of the SD card, and attach it to the SD
card.
NOTE: An SD card can store the NVRAM data of two or more machines.
5-76
9 March 2004