Canon imageRUNNER ADVANCE 4551i Service Manual page 709

COPIER > FUNCTION > CST
MF-A6R 1
Detail
Adj/Set/Operate Method
Caution
Related Service Mode
MF-A4 1
Detail
Adj/Set/Operate Method
Caution
Related Service Mode
DK1-INT1 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Required Time
DK1-SPAD 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
DK1-LIFT 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Reg Multi-purpose Tray A6R stdrd width
To register the standard value of A6R paper width (105 mm) on the Multi-purpose Tray.
Make a fine adjustment by COPIER> ADJUST> CST-ADJ> MF-A6R.
1) Set A6R paper on the Multi-purpose Tray, and set the guide so that it fits the paper width.
2) Select the item, and then press OK key.
The value is registered after automatic adjustment.
After execution, check the registered value by COPIER> ADJUST> CST-ADJ> MF-A6R, and write
it down on the service label.
COPIER> ADJUST> CST-ADJ> MF-A6R
Reg Multi-purpose Tray A4 standard width
To register the standard value of A4 paper width (297 mm) on the Multi-purpose Tray.
Make a fine adjustment by COPIER> ADJUST> CST-ADJ> MF-A4.
1) Set A4 paper on the Multi-purpose Tray, and set the guide so that it fits the paper width.
2) Select the item, and then press OK key.
The value is registered after automatic adjustment.
After execution, check the registered value by COPIER> ADJUST> CST-ADJ> MF-A4, and write
it down on the service label.
COPIER> ADJUST> CST-ADJ> MF-A4
Initialization at Deck parts replacement
To execute initialization of Paper Deck at parts replacement.
By executing this item, the lifter moves up from the lower limit position and stops when the Paper
Surface Sensor detects paper top face. The travel distance is reflected to the paper level detection
control."
When replacing the Pickup Unit/PCB/compartment
Select the item, and then press OK key.
Execute this item while there is no paper in a deck and the lifter is in stopped state.
During operation: ACTIVE, When operation finished normally: OK!
30 sec
Setting of Deck Lifter stop position
To set stop position of the lifter when opening the compartment of the Paper Deck Unit.
When 0 is set, the lifter moves down to the lower limit position when the compartment is opened.
When 1 is set, the lifer moves up to the pickup position and then the compartment opens. The
height of the Pre-separation Plate can be adjusted.
Even 1 is set, the value is returned to 0 when the compartment is opened.
When adjusting pre-separation position after replacing the Pickup Unit/compartment
Enter the setting value, and then press OK key.
Even 1 is set, the value is returned to 0 when the compartment is opened.
0 to 1
0: Stop at lower limit position (normal), 1: Stop at pickup position
0
Drive of Deck Lifter Motor
To drive the Lifter Motor of the Paper Deck.
When descent timeout alarm (04-1537) occurs, the lifter wire may be wound in the opposite
direction. The Lifter Motor is driven for approximately 5 seconds to wind the wire correctly.
At recovery from descent timeout alarm
1) Close the compartment.
2) Select the item, and then press OK key.
During operation: ACTIVE, When operation finished normally: OK!
696
8. Service Mode