Fixing System; Removing The Fixing Assembly; Removing The Fixing Main Unit - Canon imageRUNNER ADVANCE 4551i Service Manual

Fixing System

Removing the Fixing Assembly

■ Procedure
CAUTION:
The Fixing Assembly right after power OFF is hot and may cause burn injury. Be sure to perform the operation after the
assembly is surely cooled.
1. Open the Right Cover.
2. Remove the screw [1] on the front side, loosen the screw [2] on the rear side, and remove the Fixing Assembly [3].
NOTE:
When holding the Fixing Assembly [3], be sure to hold the positions shown in the figure.

Removing the Fixing Main Unit

■ Preparation
1. Remove the Fixing Assembly."Removing the Fixing Assembly" on page 261
1x
1x
[1]
[3]
[3]
261
4. Disassembly/Assembly
[2]