Canon imageRUNNER ADVANCE 4551i Service Manual page 881

SORTER > OPTION
FR-ST-PO 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
Related Service Mode
MSTP-WT 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Default Value
Amount of Change per
Unit
TRY-PSTN 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
PUN-Y-SW 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Additional Functions
Mode
Set staple free staple position: Fin-J1
To set the staple position of staple free stapling.
When 1 is set, staple position becomes the center so paper is more likely to be come off. The
staple position moves to the delivery direction for 4.0 mm and the alignment direction for 2.0 mm
inside.
Upon user's request
Enter the setting value, and then press OK key.
0 to 1
0: Corner-stapling (normal), 1: Center-stapling
0
SORTER> ADJUST >FR-STP-X, FR-STP-Y
Set wait time after manual stpl: Fin-J1
To set the duration of time to keep manual staple mode enabled after execution of manual stapling.
While manual stapling mode is enabled, other jobs are not accepted.
Upon user's request
Enter the setting value, and then press OK key.
0 to 10
sec
0
1
Set tray pstn after job complete: Fin-J1
To set the tray position after the completion of job.
When 1 is set, the tray stops at the lower limit position. Visibility of the delivered papers is improved,
but FCOT becomes longer.
Upon user's request (to improve visibility of the delivered papers)
Enter the setting value, and then press OK key.
When 1 is set, FCOT becomes longer.
0 to 1
0: Normal (priority on productivity), 1: Lower limit position (priority on visibility)
0
SORTER> OPTION> TRY-STP
When 1 in SORTER> OPTION> TRY-STP is set, the tray of the inner finisher does not down after
paper full detection.
Set of punch horz reg oprtn: Fin-J1/Y1
To set whether or not to perform the horizontal registration operation of puncher unit for matching
with the center of the paper.
When the adjustable range of the punch hole horizontal registration adjustment (PNCH-Y) is
enlarged.
Enter the setting value, and then press OK key.
Fin-Y1
When a punch hole position precision improvement mode were set, this mode is given priority to.
0: The horizontal registration operation is performed.
1: The horizontal registration operation is not performed. (fixed in the center position)
0
SORTER> ADJUST> PNCH-Y, SORTER> OPTION> PUCH-SW, SORTER> OPTION> PNCH-
SW3 (Fin-Y1 Only)
Fin-Y1
Adjustment/Maintenance> Adjust Action> Switch Finisher Puncher Mode
868
8. Service Mode