Installation Procedure
CAUTION:
Check that the main power switch is OFF and the
power plug is disconnected from the outlet.
■ Preparation of the Paper Deck Unit
1. Disconnect the Lattice Connector from the host
machine.
• 1 Wire Saddle
• 1 Connector
1x
1x
2. Pull the Release Lever and then with draw the Paper
Deck Unit until it stops.
3. Insert screwdrivers into the hole at rear left side of
the Compartment and then release the lever to open
it.
NOTE:
Insert screwdrivers into the hole indicated by the arrow.
4. Remove the Rear Cover.
• 5 Screws
5x
959
9. Installation