Canon imageRUNNER ADVANCE 4551i Service Manual page 626

COPIER > DISPLAY > ANALOG
ABS-HUM 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Appropriate Target Value
Related Service Mode
Amount of Change per
Unit
FIX-C 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Amount of Change per
Unit
FIX-E 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Amount of Change per
Unit
FIX-UE2 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Unit
Amount of Change per
Unit
■ CST-STS
COPIER > DISPLAY > CST-STS
WIDTH-MF 2
Detail
Use Case
Adj/Set/Operate Method
Unit
Amount of Change per
Unit
Display of inside moisture content
To display the absolute moisture content inside the machine detected by Environment Sensor.
When checking the moisture content inside the machine
N/A (Display only)
0 to 100
g
0 - 22
COPIER> DISPLAY> ANALOG> TEMP, HUM
1
Display of Fixing Roller center temp
To display the center temperature of the Fixing Roller detected by the Fixing Main Thermistor.
When checking the temperature at the center of Fixing Roller
N/A (Display only)
0 to 999
deg C
1
Display of Fixing Roller edge temp
To display the edge temperature of the Fixing Roller detected by the Fixing Sub Thermistor 1.
Fixing Sub Thermistor 1 is located in the rear nip inlet side of Fixing Roller.
When checking the edge temperature of the Fixing Roller
N/A (Display only)
0 to 999
deg C
1
Display of Fixing Roller edge temp 2
To display the edge temperature of the Fixing Roller detected by the Fixing Sub Thermistor 2.
Fixing Sub Thermistor 2 is located in the rear nip inlet side of Fixing Roller.
When checking the edge temperature of the Fixing Roller
N/A (Display only)
0 to 999
deg C
1
Display of MP Tray paper width size
To display the paper width size set on the Multi-purpose Tray.
When checking the paper width side set on the Multi-purpose Tray
N/A (Display only)
mm
1
613
8. Service Mode