Canon imageRUNNER ADVANCE 4551i Service Manual page 703

COPIER > FUNCTION > INSTALL
STRD-POS 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Required Time
Related Service Mode
CARD 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
E-RDS 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
RGW-PORT 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
Supplement/Memo
Auto adj frt side read pstn: DADF stream
To automatically adjust the Scanner Unit (for front side) position in feed direction when stream
reading original with DADF.
The adjustment result is reflected to COPIER> ADJUST> ADJ-XY> STRD-POS.
At DADF installation/uninstallation
1) Close the DADF.
2) Select the item, and then press OK key.
The operation automatically stops after the adjustment.
3) Write the value displayed by COPIER> ADJUST> ADJ-XY> STRD-POS in the service label.
Write the adjusted value in the service label.
At normal termination: OK, At abnormal termination: NG
10 sec
COPIER> ADJUST> ADJ-XY> STRD-POS
Card number setting
To set the card number to be used for Card Reader.
A series of numbers from the entered number to the number of cards specified by CARD-RNG
can be used.
- At installation of the Card Reader
- After replacement of the HDD
1) Enter the number, and then press OK key.
2) Turn OFF/ON the main power switch.
The card management information (department ID and password) is initialized.
1 to 2001
1
COPIER> OPTION> FNC-SW> CARD-RNG
Set use/no use of Embedded-RDS function
To set whether to use the Embedded-RDS function.
When using Embedded-RDS
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Be sure to use E-RDS, RGW-PORT, COM-TEST, COM-LOG and RGW-ADR as a set.
0 to 1
0: Not used, 1: Used (All the counter information is sent.)
It differs according to the location.
COPIER> FUNCTION> INSTALL> RGW-PORT, COM-TEST, COM-LOG, RGW-ADR
Embedded-RDS: Function to send device information such as the device counter, failure, and
consumables to the sales company's server via SOAP protocol
Set port number of Sales Co's server
To set the port number of the sales company's server to be used for Embedded-RDS.
When using Embedded-RDS
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
Be sure to use E-RDS, RGW-PORT, COM-TEST, COM-LOG and RGW-ADR as a set.
1 to 65535
443
COPIER> FUNCTION> INSTALL> E-RDS, COM-TEST, COM-LOG, RGW-ADR
Embedded-RDS: Function to send device information such as the device counter, failure, and
consumables to the sales company's server via SOAP protocol
690
8. Service Mode