COPIER > ADJUST > LASER
LDADJ1-K
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
LDADJ2-K
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
LDADJ3-K
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
LDADJ4-K
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
LDADJ5-K
1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Magnification between A-B laser (K)
When replacing the laser scanner unit, enter the value of service label stuck on the laser scanner
unit.
- When replacing the CCD unit (CCD PCB)/clearing RAM data
- When replacing the laser scanner unit
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
-512 to 511
0
Magnification between A-C laser (K)
When replacing the laser scanner unit, enter the value of service label stuck on the laser scanner
unit.
- When replacing the CCD unit (CCD PCB)/clearing RAM data
- When replacing the laser scanner unit
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
-512 to 511
0
Magnification between A-D laser (K)
When replacing the laser scanner unit, enter the value of service label stuck on the laser scanner
unit.
- When replacing the CCD unit (CCD PCB)/clearing RAM data
- When replacing the laser scanner unit
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
-512 to 511
0
Phase difference between A-B laser (K)
When replacing the laser scanner unit, enter the value of service label stuck on the laser scanner
unit.
- When replacing the CCD unit (CCD PCB)/clearing RAM data
- When replacing the laser scanner unit
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
-512 to 511
0
Phase difference between A-C laser (K)
When replacing the laser scanner unit, enter the value of service label stuck on the laser scanner
unit.
- When replacing the CCD unit (CCD PCB)/clearing RAM data
- When replacing the laser scanner unit
Enter the setting value, and then press OK key.
After the setting value is changed, write the changed value in the service label.
-512 to 511
0
670
8. Service Mode