Canon imageRUNNER ADVANCE 4551i Service Manual page 874

SORTER > ADJUST
INF-ALG2 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Supplement/Memo
Amount of Change per
Unit
CENT-ALG 1
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Unit
Default Value
Related Service Mode
Amount of Change per
Unit
Adj alignment position (LTR): Fin-J1
To adjust the position of the Alignment Plate when aligning LTR paper.
As the value is incremented by 1, distance between the Alignment Plates is narrowed by 0.1 mm.
- When the paper alignment position is displaced.
- When replacing the Finisher Controller PCB/clearing RAM data
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
The Alignment Plate moves to the LTR paper width position.
2) Set LTR paper on the Processing Tray.
3) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
4) Check the operation of the Alignment Plate.
5) Repeat steps 3 and 4 until the completion of adjustment.
6) Remove the paper on the Processing Tray.
After the setting value is changed, write the changed value in INF-ALG1 of the service label.
-50 to 50
mm
0
SORTER>ADJUST>INF-ALG1
The adjustment result is reflected in SORTER> ADJUST> INF-AL1.
0.1
Adj ctr align standard pstn: Fin-J1/Y1
To adjust the standard position for the center alignment
As the value is incremented by 1, the standard position for the center alignment moves by 0.1 mm.
+: Toward rear
-: Toward front
- When the standard position for the center alignment is misaligned
- When the paper alignment position is displaced.
- When replacing the Finisher Controller PCB/clearing RAM data
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
This adjustment influences alignment operation and staple position.
Fin-J1:
Adjust the alignment width with INF-ALG1/2.
After the setting value is changed, write the changed value in the service label.
Fin-Y1:
Adjust the alignment width with ST-ALG1/2.
Fin-J1: -10 to 10
Fin-Y1: -50 to 50
mm
0
Fin-J1:
SORTER> ADJUST> INF-ALG1, INF-ALG2
Fin-Y1:
SORTER> ADJUST> ST-ALG1, ST-ALG2
0.1
861
8. Service Mode