Removing The Developing Cylinder - Canon imageRUNNER ADVANCE 4551i Service Manual

NOTE:
When the consumable parts have been replaced, be sure to clear the parts counter shown below in service mode.
• COPIER > COUNTER > DRBL-1 > DV-UNT-K

Removing the Developing Cylinder

■ Preparation
CAUTION:
Do not touch the Developing Cylinder or give a shock to it.
CAUTION:
Points to Note at Installation
• Many self tapping screws are used in the Developing Assembly. Do not overtighten the self tapping screws, or the
screw holes will break.
1. Remove the Developing
■ Procedure
1. Remove the Top Cover [1].
• 4 Screws [2]
2. Remove the ring [1], gear [2], Parallel Pin [3], and Shaft Support [4].
Assembly."Removing the Developing Assembly" on page 252
4x
[4]
[3]
[2]
[1]
[2]
[1]
253
4. Disassembly/Assembly