Canon imageRUNNER ADVANCE 4551i Service Manual page 760

COPIER > OPTION > NETWORK
WLANPORT
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
RAW-PORT
LINKWAKE
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
WIFIRFCH
Amount of Change per
Unit
BLEPOWER
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
2 Set of port filter at wireless LAN side
*Operation on this item is restricted by the setting of [Restrict Service Representation Access].
To set whether to open all ports at the wireless LAN side.
When 0 is set, only the specific port is opened (filter is enabled).
Set 1 when using an application which uses a port other than the specific port. All ports are opened
(filter is disabled).
Upon user's request
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Open the specific port, 1: Open all ports
0
2 [For customization]
2 Set of deep sleep recovery at link-up
To set whether to recover from deep sleep when link-up (disconnection and then connection of
LAN cable) is detected.
Set 0 if the closest hub or switch chatters at link-up. It can prevent recovery from deep sleep
triggered by chattering.
When the machine recovers from deep sleep due to chattering of the closest hub or switch
1) Enter the setting value, and then press OK key.
2) Turn OFF/ON the main power switch.
0 to 1
0: Not recovered, 1: Recovered
1
2 For R&D
1
2 Set of Bluetooth radio field strength
To set the radio field strength for transmission over BLE (Bluetooth Low Energy).
As the value is changed by 1, the radio field strength is changed by 1 dBm.
When radio field strength of BLE is not appropriate
1) Enter the setting value (switch negative/positive by -/+ key) and press OK key.
2) Turn OFF/ON the main power switch.
Do not change the setting in Singapore. It is prohibited by law.
-10 to -1 (-10 to -1 dBm)
-5
747
8. Service Mode