Canon imageRUNNER ADVANCE 4551i Service Manual page 863

OPTION
FEEDER > OPTION
SIZE-SW 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
R-ATM 1
Detail
Use Case
Adj/Set/Operate Method
Display/Adj/Set Range
Default Value
R-OVLPLV 2
Detail
Use Case
Adj/Set/Operate Method
Caution
Display/Adj/Set Range
Default Value
Related Service Mode
ON/OFF of mixed paper detection:AB, Inch
To set ON/OFF of mixed paper detection: AB configuration and Inch configuration
When enabling to mix AB and Inch configuration sizes original
Enter the setting value, and then press OK key.
0 to 1
0: OFF (Mixed paper is not detected), 1: ON (Mixed paper is detected)
Set double fd dtct highland mode; S-pass
To set the Double Feed Sensor of the Single pass DADF to the highland mode.
Set 1 if the installation site is above the altitude of 2,000 meters.
When the installation site is above the altitude of 2,000 meters at installation
Enter the setting value, and then press OK key.
0 to 1
0: Normal, 1: Highland mode
0
Set double feed dtct threshold VL;S-pass
To set the threshold value at which the Double Feed Sensor of the Single pass DADF judges
whether papers are double fed.
Decrease the value if single feed of paper is incorrectly detected as double feed.
Increase the value if double feed of paper is incorrectly detected as single feed.
When double feed is incorrectly detected with special paper not defined in the specifications
Enter the setting value (switch negative/positive by -/+ key) and press OK key.
In the case of highlands, be sure to set R-ATM in advance.
-3 to 3
0
FEEDER> OPTION> R-ATM
850
8. Service Mode