Resetting Interface Module To Factory Settings - Siemens SIMATIC ET 200MP System Manual

9.5

Resetting interface module to factory settings

Introduction
When you reset to factory settings
● the interface module is set to the delivery condition and
● the properties of the interface module are set to the following values:
Table 9- 1
Properties
Parameter
IP address
Device name
MAC Address
I&M data
Firmware version
Note
Failure of downstream stations is possible
Downstream stations on a bus segment can fail when the factory settings are restored on an
interface module.
Note
Substitute value behavior of the installed I/O modules during reset to factory settings
With "Reset to factory settings", the I/O modules in the station assume the non-configured
state, which means that no input data is acquired and no output data is output.
Reset options
Online via PROFINET IO (with STEP 7)
Requirements
There is an online connection to the interface module that is to be reset to the factory
settings.
Procedure
Connect the PG/PC to the PROFINET IO interface of the ET 200MP.
Reference
Further information on the procedure can be found in the STEP 7 online help.
ET 200MP Distributed I/O System
System Manual, 01/2013, A5E03723484-01
Properties of the interface module in delivery condition
Value
Default setting
not present
(parameterizable when resetting: "Retain IP Address" / "Delete IP Address")
Not present
present
Identification data (I&M0) present
Maintenance data (I&M1, 2, 3) not present
present
9.5 Resetting interface module to factory settings
Maintenance
93