Avaya DEFINITY Manual page 53

Installation: Task 4a — Installing a Terminal Using a
Direct Connection to a DC Switch
3. Follow Step a or b to connect the terminal to the MAPD system.
a. If connecting to a DCE port,
b. If connecting to a DTE port, attach the male end of another
4. Plug the terminal power cord into a wall outlet and power on the terminal.
5. Set the terminal options. See Appendix B,
complete list of option settings for supported terminals.
1. Attach one end of an ED1E434-11G311 cable (supplied with
the MAPD system PEC) to the female connector on 116A
isolator.
2. Attach the other end of the cable to the RS-232 connector on
the back of the terminal. Then go to step 4.
H600-258 G-1 null modem to the female connector on the 116A
isolator.
For a 715 BCT, attach the other end of the ED1E434-11G311
cable to the DCE connector on the back of the terminal. Then
go to step 4.
For a 513 or equivalent BCT, attach the other end to the
female connector on an H600-258 G-1 null modem.
1. Attach one end of an ED1E434-11G311 cable (supplied with
the MAPD system PEC) to the female end of the null modem.
2. Then connect the other end of the G311 cable to the RS-232
connector on the back of the terminal. Go to next step.
NOTE:
When installing a serial printer on all but a 610 or 615 BCT, set the
options on the printer as described in the manual supplied with the
printer, then set the corresponding options on the terminal to match.
On the 610/615, set the terminal options first, then set the printer
options.
If the terminal is installed correctly (and the MAPD system is in
either the AINIT or ASAI state), the screen displays the login
prompt.
If the terminal does not display the login prompt when the MAPD
system is in the above state, try pressing Return a few times. If the
login prompt still does not appear, write down the state displayed on
the LCD and then see the troubleshooting procedure for terminal
connections in Appendix D,
''Terminal Option Settings,''
''Troubleshooting Procedure.''
Issue 3 May 2002
for a
2-29