Avaya DEFINITY Manual page 44

Installing the MAPD
Avaya Avaya Avaya
. . . .
. . . .
6
. . . .
3
. . . .
. . . .
1
. . . .
D
. . . .
A . . . .
POWER
B
POWER UNIT UNIT CLOCK EXPN INTFC
TONE-
1 2
SERVICE
TOP WHITE
BOTTOM PURPLE
TWO SLOTS
1
Hold the system assembly by the top
and bottom edges of the TN801B
MAPD Board
3
Insert the assembly and lock it in place by pushing up the securing latch
The MAPD system will automatically boot when seated in the slots of
a switch that is powered on. Damage to the disk could occur if the
assembly is removed while booting. Be sure that the assembly is
properly aligned in the slot, and then insert it with a single, firm push.
Do not adjust or attempt to reinsert the assembly once it has started
to boot.
Figure 2-11. Installing the TN801B in a DEFINITY ECS (DC)
6. Insert the assembly and lock it in place by pushing up the securing latch. If
the switch is powered on, the MAPD system will boot automatically. If the
switch is not powered on, wait until it is, and then proceed to Step 6.
!
2-20 Issue 3 May 2002
Avaya Avaya Avaya Avaya
Z Z Z
1 1 1
0 0 0
0 0 0
C C C
A A A
P P P
P. P. P.
. . . .
. . . .
B B B
. . . .
. L . . . L L
. . . .
A A A
. . . .
N N N
. . . .
. . . .
K K K
3 4 5 6 7 8 9
LCD
WARNING:
The MAPD system will automatically boot when seated in the slots of
a switch that is powered on. Damage to the disk could occur if the
assembly is removed while booting. Be sure that the assembly is
properly aligned in the slot, and then insert it with a single, firm push.
Do not adjust or attempt to reinsert the assembly once it has started
to boot.
Avaya Avaya Avaya Avaya Avaya
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
. . . . . .
10 11 12 13 14 15 16
PURPLE SLOTS
(PORT SLOTS)
2
Line up the MAPD Board
with the bottom guide
of the righmost of the 3 slots
reserved for the MAPD
system in the switch carrier
Avaya Avaya
. . .
. . .
6
. . .
3
. . .
. . .
1
. . .
D
. . .
. . B .
POWER UNIT
17 18 19 20