Avaya DEFINITY Manual page 41

Installation: Task 3 — Installing the MAPD Assembly in
the Switch
5. Insert the assembly and lock it in place by pushing up the securing latch. If
the switch is powered on, the MAPD system will boot automatically. If the
switch is not powered on, wait until it is, and then proceed to Step 6.
!
6. As the MAPD system comes up, watch the Liquid Crystal Display on the
faceplate (see Figure 2-7). The LCD identifies the MAPD states and
alarms.
the following states (in order):
WARNING:
The MAPD system will automatically boot when seated in the slots of
a switch that is powered on. Damage to the disk could occur if the
assembly is removed while booting. Be sure that the assembly is
properly aligned in the slot, and then insert it with a single, firm push.
Do not adjust or attempt to reinsert the assembly once it has started
to boot.
When the MAPD system is coming up, the LCD should display
FWBOOT (firmware board tests)
PCBIOS (Pentium processor card diagnostics)
OSINIT (operating system initialization)
PGMFW (update MAPD FLASH PROMS, if necessary)
AINIT (MAPD System Initialization)
NOTE:
If the system does not come up to the AINIT state within 10
minutes (4 to 7 minutes is average), contact the Technical
Service Center (TSC) for assistance.
ASAI x (MAPD running with x established ASAI links)
Issue 3 May 2002 2-17