Avaya DEFINITY Manual page 309

Upgrading the MAPD System
8. Boot from the PCMCIA Disk by pressing
succession when you see the PCMCIA drive bootable line appear on
the screen.
!
At this point, the system will boot from the PCMCIA Disk, and a screen similar to
the following appears:
Booting UnixWare...
UnixWare 2.1.2 for the Intel386(tm) Family
Copyright 1984-1995 Novell, Inc., 1996 The Santa Cruz Operation, Inc.
All Rights Reserved.
TN800 driver (mapdmux) - Version 0.1
MAINT DRIVER INIT
RMB DRIVER INIT
0:0,7,0: HBA
0,0,0: DISK
1:0,7,0: HBA
0,0,0: DISK
NOTE:
If the screen shows LynnSoft PC Card Software loaded (see the following
screen), then you did not successfully boot from the PCMCIA Disk. In this
case, you must reset the system (either by power down, reboot, or through
the remote maintenance interface) and attempt again.
The login prompt appears when the system has finished rebooting.
NOTE:
When the system is rebooted, the console will be reset while the firmware is
downloaded. The download process should take less than 30 seconds after
the initial login prompt is displayed. Press the
login prompt again.
WARNING:
Once the PCMCIA drive bootable line appears on the screen,
you only have 5 seconds to enter the
enter it in time, you must reset the system (either by power down,
reboot, or through the remote maintenance interface) to attempt
again.
: (ide,1) Generic ESDI/IDE/ATA
: Generic IDE/ESDI
: (ide,2) Generic ESDI/IDE/ATA
: Generic IDE/ESDI
.
.
.
twice in quick
CTRL C
sequence. If you fail to
CTRL C
1.00
1.00
key to display the
RETURN
Issue 3 May 2002 H-3