Avaya DEFINITY Manual page 43

Installation: Task 3 — Installing the MAPD Assembly in
the Switch
3. Install the 116A isolating data interface
a. Attach the male end of a null modem (supplied with the MAPD
b. If you are attaching anything other than an isolated modem to the
4. Insert the SanDisk PCMCIA FlashDisk that came with the system in the
rightmost PCMCIA slot in the faceplate of the TN801B board. The top of
the disk should be facing left.
5. Insert the system assembly (see
follows:
Holding the system assembly by the top and bottom edges of the TN801B
MAPD Board, line up the MAPD Board with the bottom guide of the right
most of the 3 slots reserved for the MAPD system in the switch carrier.
!
system PEC) to the RS-232C connector on the MAPD external
cable labeled Admin/Port B. Attach the male connector of a 116A to
the other end of the null modem.
Maint/Port A connector on the MAPD cable, you must install an
isolator on this interface also. Attach the male end of a null modem
(supplied with the MAPD system PEC) to the RS-232C connector on
the MAPD external cable labeled
Maint/Port A. Attach the male connector of a 116A to the other end
of the null modem.
CAUTION:
The faceplate of the MAPD system is designed to be easily removed.
Do not lift the assembly with the faceplate alone.
Figure 2-10) into the switch cabinet as
Issue 3 May 2002 2-19