Siemens SIMATIC ET 200pro FC-2 Operating Instructions Manual page 86
Low voltage converter for the distributed i/o system
Hide thumbs
Also See for SIMATIC ET 200pro FC-2:
- Function manual (344 pages) ,
- Operating instructions manual (270 pages) ,
- Original instructions manual (256 pages)
Table of Contents
Advertisement
Commissioning
6.6 Quick commissioning
5. When the USB interface is appropriately set, then the "Accessible nodes" screen form
shows the inverters that can be accessed.
If you have not correctly set the USB interface, then the following "No additional nodes
found" message is displayed. In this case, follow the description below.
6. Select the inverter ☑.
7. Press the "Accept" button.
You have transferred an inverter accessible via the USB interface into your project.
❒
Setting the USB interface in STARTER
Procedure
1. Set the "Access point" to "DEVICE (STARTER, Scout)" and the "PG/PC interface" to
"S7USB".
2. Press the "Update" button.
You have set the USB interface.
❒
STARTER now shows the inverters connected via USB.
84
Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257324B AF
SIMATIC ET 200pro FC-2 converter
Advertisement
Table of Contents
