Siemens SIMATIC ET 200pro FC-2 Operating Instructions Manual page 107

Data block
Values, parameter 1
Values, parameter 2
...
Values, parameter m
Table 7- 7 Response, if the inverter has executed the change request
Data block
Header
Table 7- 8 Response if the inverter was not able to completely execute the change request
Data block
Header
Values, parameter 1
Values, parameter 2
SIMATIC ET 200pro FC-2 converter
Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257324B AF
Byte n
Format
02 hex:
Integer 8
03 hex:
Integer 16
04 hex:
Integer 32
05 hex:
Unsigned 8
06 hex:
Unsigned 16
07 hex:
Unsigned 32
08 hex:
Floating Point
0A hex:
Octet String
0D hex:
Time Difference
34 hex
: TimeOfDay without date indication
35 hex
: TimeDifference with date indication
36 hex
: TimeDifference without date indication
41 hex:
Byte
42 hex:
Word
43 hex:
Double word
Value of the 1st index
...
...
...
...
Byte n
Reference (identical to a change request)
01 hex (ID of drive objects, at G120 al-
ways = 1)
Byte n
Reference (identical to a change request)
01 hex (ID of drive objects, at G120 al-
ways = 1)
Format
40 hex: Zero (change request for this data
block executed)
44 hex: Error (change request for this data
block not executed)
Only for "Error" - error value 1
You can find the error values in the table at the end of this section.
Only for "Error" - error value 2
Error value 2 is either zero, or it contains the number of the first index where the error oc-
curred.
...
7.4 Drive control via PROFIBUS and PROFINET
Bytes n + 1
Number of index values
00 hex ... EA hex
Bytes n + 1
02 hex (change request successful)
Number of parameters (identical to a change
request)
Bytes n + 1
82 hex: (Inverter was not able to completely
execute the write request)
Number of parameters (identical to a change
request)
Number of error values
00 hex
01 hex or 02 hex
Advanced commissioning
105
n
n
0
2
n
0
2
4
6
8