Installation
4.7 Mounting the converter
Figure 4-10
Figure 4-11
Required tool for mounting: cross-head screwdriver, size 2.
Procedure
1. Plug the converter into the bus module so that the two domes on the rear engage in the
guide holes of the bus module.
2. Holding the converter firmly against the module rack, screw it in place with 4 screws on
the top and 4 screws on the bottom.
The upper 4 screws simultaneously fasten the bus module.
44
Taking the converter out of the packaging
Placing the converter on an even surface
Operating Instructions, 04/2018, FW V4.7 SP10, A5E34257324B AF
SIMATIC ET 200pro FC-2 converter