Stop; Components That Can Be Started And Stopped - Avaya CallPilot 202i Manual

Using CallPilot Manager to monitor hardware

Stop

A stop removes the component from service immediately, regardless of whether the
component is currently processing calls. All active calls are dropped. Typically, you perform a
stop only when severe problems that affect a large number of incoming calls occur or if your
organization determines a special need for it.

Components that can be started and stopped

You can start and stop only the following components.
Note:
If you want to start or stop more than one or two multimedia (DSP) or call (DS30X) channels,
use the Multimedia Monitor or Channel Monitor. For instructions, see
with the Multimedia and Channel Monitors
Motherboard (IPE server)
Time Switch
Multimedia channels
Channels
DS30X link
To start or stop a component
1. Run CallPilot Manager and log on.
2. In CallPilot Manager, click Maintenance, Maintenance Admin.
3. Click the plus sign (+) beside the CallPilot server to expand the component tree.
4. Continue clicking the plus sign (+) until the component with which you want to work is
5. Click the hardware component that you want to start or stop.
56 Avaya CallPilot 202i Server Maintenance and Diagnostics
Component
The Maintenance page appears.
visible.
The Maintenance page refreshes to show details about the component.
on page 63.
Effect of stopping
Removes all call processing resources on the selected
board from service.
You cannot perform maintenance administration on
the time switch.
Removes the selected DSP from service.
Removes the selected DS30X channel from service.
Removes the selected DS30X link from service.
Section C: Working
December 2010