Manual Structure - Konica Minolta CA-410 Instruction Manual

Manual Structure

This manual is divided into sections as shown below according to the contents.
This section explains how to connect a probe, AC power, turn the power ON ( | )/OFF (), and input the vertical
synchronization signal.
Connections
Explains how to connect probes and the power cord, and how to input the vertical
synchronization signal.
* Before turning on the power: Refer to pages 107–117 if using RS-232C or USB communication.
Turning the Power ON ( | )/OFF ()
Explains how to turn the power ON ( | )/OFF () and the instrument status at Power-ON ( | ).
• The Measurement Preparation, Calibration/Settings, and Measurement sections explain the procedure up to
measurement.
The Measurement Preparation section explains preparations (instrument setting, zero calibration) that are
required prior to measurement.
Zero calibration
Explains the zero calibration method.
(Measurement cannot be performed if zero calibration is not completed.)
Measurement Condition Settings
Explains the various settings according to the purpose of measurement
Sync Mode / Meas Speed / Trigger Mode / Interval Meas /
Interval Alert / JEITA freq resolution
To Calibration/Settings section
* Go to the Measurement section if performing measurement using Konica Minolta's calibration standard.
Selecting a Probe No�
Explains how to select the probe whose measured value is to be displayed.
40
P. 45
P. 49
P. 52
P. 54
P. 65