Setting The Poe Card Power Detect Type - Avaya 8300 Configuration

Procedure steps
Set the power limit for the card power allocation by using the following command:
config poe card <slotlist> power-limit
Important:
Use the show poe sys info command to display the system power information.
Variable definitions
Use the data in the following table to help you use the config poe card <slots> power-
limit command.
Variable
power-limit <37-800>

Setting the PoE card power detect type

Set the power device detect type for the PoE card.
Procedure steps
Set the power device detect type by using the following command:
config poe card <slotlist> pd-detect-type
Variable definitions
Use the data in the following table to help you with config poe card <slotlist> pd-
detect-type command.
pd-detect-type <802dot3af|
802dot3af_and_legacy>
Configuration — Power over Ethernet
Sets the power limit on the PoE card. The power limit can be
set to any amount from 37 to 800. The default power limit for
each card is 200 W. The maximum power limit that can be
allocated to a card is 800 W. The actual power allocated to a
card, however, is limited by the power available from the system
power pool.
Variable
Setting the PoE card power detect type
Value
Value
Sets the power device detect type.
May 2011 43