Figure 37: Removing/Replacing The Dvd Drive - Fiery E-8100 Installation And Service Manual

S
ERVICE
T DVD
O REMOVE THE
1. Shut down and open the E-8100 (see pages
To remove the DVD drive, you must remove the left, right, and front panels, the Component
Sled, and the switch bank assembly.
2. Remove the power cable from the back of the DVD drive.
3. Remove the DVD drive ribbon cable from the back of the DVD drive.
4. Remove the Component Sled from the chassis, and then remove the switch bank assembly
from the Component Sled (see
5. Remove the four screws that secure the DVD drive to the switch bank assembly.
Set aside the screws so that you can replace them later.
N : On some systems, a small metal post in the switch bank assembly is used in place of
OTE
one of the screws.
6. Remove the DVD drive from the switch bank assembly.
Screw
(1 of 4)
F 37:
IGURE
P
ROCEDURES
DRIVE
page
Removing/replacing the DVD drive
46 and 48).
93).
Component Sled
Screw (1 of 3)
Switch bank assembly
DVD drive
N :
Some switch bank assemblies
OTE
have a metal post in this location that
is used in place of the screw.
Switch bank assembly
97